LD定量脱压式稀油分配器定量容积式稀油分配器
产品尺寸图
技术参数
*油量表示方法：
（注：当所有出油口油量值一样时，只用一个油量值表示）
例1 LD5-2表示为5位分配器,第1, 2,3,4,5 出油口油量全部为0.2ml每次。
例2:LD5-53235表示为5位分配器,第1 ,2 ,3 ,4 ,5出油口油量分别为0.5; 0.3; 0.2 ;0.3;0.5ml每次。
注：其中：7；8；9；10位，为5位和2；3；4；5位组合。6位为3位与3位的组合。
*oil quantity representation method:
(note: when the oil value is the same, only one oil value is used)
Example 1: LD5-2 indicates LD model and the amount of 1 and 2 oil outlet in 2 allocator is 0.3ml each time.
Example 2: LD5-53235 indicates 5 allocators, and 1, 2, 3, 4, 5 outlet flow rate respectively is 0.3ml, 0.5ml, 0.3ml, 0.5ml, and 0.4ml each time.
Note:among them: 7,8,9,10 bits is the combination of 5 bits and 2,3,4, or 5 bits.
The 6 bits, the combination of 3 and 3 bits.
型号说明
注：如没有特殊要求，出油口油量默认为3，代表0 . 3 m L每次。
工作原理
工作原理：A：计量活塞动作行程 B ：伞形双向阀动作行程见上图，从润滑泵压送的油从主管A注入，并将伞形双向阀B向推开流入，通过通路C压送活塞室到F内。受压力油作用下计量活塞向下动作弹簧G被压缩蓄油，从而进行计量蓄油，当主管A内油压被释放〈即卸压〉，伞形阀B因压力差而动作，同时开启吐出口E，于是活室内计量蓄油通过吐出口E送入油管H而将油输送到润滑点， 信号销I当计量蓄油时突出．而供油给润滑点时缩回，从而确认分配动作完成情况。
A: metering piston action schedule B: the action trip of the umbrella type two-way valve is shown in the figure above. The oil from the lubrication pump is injected from the director A, and the umbrella-type two-way valve B is pushed open. Push the piston chamber to F through the channel C.The piston moves downward under the action of pressure oil.
The spring G is compressed.Thus the measurement of oil storage.When the oil pressure is released in charge of A(the discharge pressure). The umbrella valve B moves with pressure difference. At the same time, it opens the outlet E, so the living room measures the oil storage.
The oil is transported to the lubrication point by outlet E to the pipe H, and the signal pin I is prominent when measuring the oil storage. When the oil is supplied to the lubrication point, it is retracted to confirm the completion of the distribution.
